HIGH HEAT RESISTANT BLACK TO 600 DEGREES C 250ML

Product High Heat Black Matt Paint
Type Solvent based Silicone Alkyd High Heat Paint.
Intended Use
The paint is only suitable for use on ferrous Metals such as wood burning stoves, barbeques,
domestic and industrial stoves, furnace chimneys, grates and exhausts.
Special Features A fast drying, protective and decorative paint suitable for temperatures of up to 600° C
Preparation
The surface must be clean, dry and free from grease, dust rust and other contaminants.
Remove all rust with a scrapper or use Rustins Rust Remover. If the product should only be
applied to bare metal and not previously coated surfaces.
Application
Stir well before use until there is no sediment on the bottom of the tin. Apply with a bristle paint
brush. The paint may be sprayed but may require dilution with Xylene Thinners.
Coats
Only one light coat should be applied. If a heavy coat or more than one coat is applied it is
possible that the paint will flake from the surface.
Drying Time
The surface will be touch dry within 15 minutes and can be handled in 1 hour in good
conditions. The painted article if air dried will become fully cured once it has been heated
up to between 200 - 220° C for approximately 20 minutes.
Re-coating Time The paint should not be recoated.
Application Temp. Ideally 15-25°C. Do not use below 10°C, or in conditions of high humidity.
Coverage 15 sq metres/litre per coat depending type of application and surface.
Maintenance The previous coat will need to be removed if recoating becomes necessary.
Compatibility N/A
Settlement Stir well before use.
Shelf-life/Storage
The shelf life of the product is 2 years. It is preferable to store the product in a cool place.
It is important to replace the lid and ensure an airtight seal after use. NOTE: The product may be
used after shelf life has expired but should first be checked to ensure that there is no deterioration
of quality.
Hazards
Flammable. Keep out of reach of children. Keep away from sources of ignition- no
smoking. Avoid contact with skin and eyes. Use only in well ventilated areas.
A full Safety Data Sheet is available upon request or on Rustins Web Site..
Clean-Up
Remove as much product as possible from brushes before cleaning. Clean whilst wet with
Rustin Cellulose Thinners or Xylene based Thinners. Hard brushes can be cleaned with Rustins
Brush Restorer.
Sizes 250ml 500ml